SFP-transceivermodul BlueOptics 3000-079-BO 155 Mbit/s

The BlueOptics 3000-079-BO 155 Mbit/s SFP transceiver module is a compact fiber optic interface designed for single-port insertion in networking equipment that accepts SFP form-factor modules. The module supports a maximum data transfer rate of 155 Mbit/s and is finished in a silver housing. Its design offers a standardized small form-factor compatible with switches, routers and media converters that use SFP ports.

Advantages

This SFP transceiver provides a reliable fiber link for low- to mid-speed network segments with a mean time between failures (MTBF) of around 1,000,000 hours. The compact SFP form factor allows hot-pluggable replacement and flexible deployment. The module’s silver housing and standardized connector help ensure mechanical compatibility and straightforward installation into devices that support SFP modules.

Suitable for

• Connecting fiber links between switches or routers with SFP ports
• Extending network segments that require up to 155 Mbit/s bandwidth
• Media converters and access devices that accept SFP transceivers
• Environments where a compact, hot-pluggable fiber interface is needed

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 155 Mbit/s
• Interface: fiber optic SFP connector
• Housing colour: silver
• Reliability (MTBF): approximately 1,000,000 hours

How to use

Insert the SFP transceiver into an empty SFP slot of a compatible network device while the device is powered on or per vendor guidelines for hot-plugging. Ensure the module is fully seated and latched, then connect the appropriate fiber optic cable to the transceiver’s connector. Configure the device’s port settings to match the desired link speed and duplex as required by the network. Monitor link status indicators on the host device to verify successful link negotiation.

Recommendations

Use clean, undamaged fiber patch cables and follow standard fiber handling procedures to prevent contamination of the optical interfaces. Verify compatibility with the host device’s supported SFP types and firmware, and check link settings after installation. Keep spare modules in protective caps when not in use.